
Joined: 08 Apr 2004
Posts: 2189
|
Macerator
I have just installed a macerator toilet as a cloak room, so we now have a toilet on both levels of our house.
I got the macerator and toilet as a complete set from www.plumbworld.co.uk for £180 delivered.
The macerator is made by Hydrolux and has 3 inlets (toilet, basin & shower / bath) and I am using 2, toilet and hand basin.
All in all I am quite happy with the setup, the macerator can only just be heard over the flush so quite quiet really and it only blasts for about 2-3 second intervals at a time.
The problem I have is the water level in the toilet bowl is quite high, the water level is approx. halfway up the water bowl, I don't see any adjustment on the macerator air pressure switch (in fact you can't see the air pressure switch unless you strip the macerator down).
I just wandered if there is anything I can do to reduce the water level in the toilet bowl?
Installation is as follows.
3 inlets -
1 x toilet inlet used
1 x shower / bath inlet blanked off (this is at the bottom of macerator)
1 x basin inlet used (top of the macerator) I have a 32mm waste pipe fed into this inletwhich is running slightly downhill towards macerator over approx. a 1.5m run
Outlet
Outlet is fitted with a 40mm waste pipe running straight up by 1.2m with a non-return valve installed close to macerator and then into a sweeping 90o bend and runs slightly downhill for approx. 1.4m to the main down pipe for waste. _________________ Ruu
Own original or destroy backup.
Email ruu_burns@yahoo.co.uk
*** Discount on discs? Logon to DiskDepot with - username: disqworld password: diskdepot ***
|